SSLIGHT

Controller

Model Name BBC1000

Bang bang controller

Product Description: The BBC1000 controller is the ultimate controller for producing various display effects with bang bang modules.
It can display effects in both RGB mode and single color mode, offering 8 RGB effects, including rainbow flashing, and 8 single color effects, including sequential flashing. Additionally, the speed can be adjusted using the speed control switch, and desired effects can be selected via dip switch settings.
Experience the perfect controller that fully maximizes the performance of bang bang modules with the BBC1000

[Operation Instructions]

(1) Ensure the maximum distance between module does not exceed 20cm.

(2) Use only our converter (SMPS).

(3) Use only our 4-wire (AWG#18) cables for power and module connections.

(4) Up to 1,000 modules can be connected in series.

(5) Check and follow the LED module direction (signal direction). Installing modules in reverse may damage the LEDs.

(6) Seal the end wires of the modules with insulation tape.

(7) The BBC1000 controller is compatible with bang bang (BBL) modules.

(Not compatible with other modules and controllers)

(8) Verify the compatible module model name when ordering products.

[Effect Modes]

(1) RGB Mode

- Effect 1 : Rainbow

- Effect 2 : Rainbow (High Speed)

- Effect 3 : RGB Snowfall

- Effect 4 : RGB Monorail

(2) The four effects are displayed sequentially and automatically.

Selection of effects and timing is not possible.

[Precautions]

(1) Please connect the power after confirming the connection method and specifications of the product.

(2) Do not disassemble the product.

(3) Ensure the power is off during any work.

(4) Install in a well-ventilated area, away from direct sunlight.

(5) This product is not compatible with previous bang bang models.

Always verify the compatible model name.

[NOTE]

Any defects caused by not following the precautions will not be covered by warranty or replacement.